Hello gang
I wonder if you can help me. I am trying to use editor for the first time and create a simple programme going from 14-42hz.
I downloaded editor and created a couple of segments. However when i click 'run segment' it comesup with 'the serial port is not open. do you want to open it?' I click yes and it comes up with the same. I have tried both available ports Com 1 and 3 in the editor but it asks the same question and nothng runs through my procyon.
Any ideas? I think my USB connection isn't set up properly with the Procyon but not sure why tbh.
Knowing me its probably something silly, im not good with all this techie stuff!
Thanks, Jamie
Bookmarks