It stop syncing the AudioStrobe CD

[sunzhuo]

I just got my procyon today. I tried a session and the AudioStrobe CD "Requiem", it worked fine. Then I ran another session. After that I back to the mode "AS" again to listen the AudioStrobe CD, but this time it stop syncing the same track. I rebooted the machine and replug everything but it also didn't flash light. In mode "session" it can works. What's the problem? Please help me!

[Andy]

There's a few possibilities.

1. Make sure you have the Procyon in AS mode
2. Make sure the CD volume is up high enough
3. Make sure the cable going from the CD to the Procyon is good.

[sunzhuo]

There's a few possibilities.

1. Make sure you have the Procyon in AS mode
2. Make sure the CD volume is up high enough
3. Make sure the cable going from the CD to the Procyon is good.

I am sure that these are going well. I set the mode to AS and I can hear the music through procyon and it's volume reached the maximum. Sometime the glasses flashes a bit but not like before.

[RichardHK]

I am sure that these are going well. I set the mode to AS and I can hear the music through procyon and it's volume reached the maximum. Sometime the glasses flashes a bit but not like before.

Are you sure your batteries are OK? Maybe you have old batteries and you have run them down?? Try a new set. Or maybe you are using rechargables which have lower output voltage and may not work well??

Just a thought. Still on my first set of batteries for my Procyon!

[sunzhuo]

I find out the problem. The volume was low. Although I thought the volume of CD player reached the upmost, there was much space left to go. I turned up then everyting worked.