Help to upload new OS for Proteus
I'm trying to update my OS to 2.5 or 2.8, mainly to get access to the new feature of 5 configurable levels of duty cycle of the lights.
I an connect to the 2.5.1 editor fine and it works fine with control from the computer. When I go to upload the new OS , the SW shows the two graphic comments and progress bars of `uploading code section 1 and section 2' . But when I switch the unit off and on It still show that OS 2.3 is onboard.
Aby suggestions?
Re: Help to upload new OS for Proteus
Are you using a USB to RS-232 adapter? If so, then read through this thread for some tips: http://www.mindplacesupport.com/foru...hread.php?t=37
Let me know if that helps!
-Andy.
Re: Help to upload new OS for Proteus
Thanks Andy,No I'm using a PCI serial card . The unit is working fine otherwise as far as designing sessions on the PC and running them on the Proteus via the serial connection.
Re: Help to upload new OS for Proteus
Try reducing the speed of your serial connection as per this post: http://www.mindplacesupport.com/foru...?p=215#post215
Re: Help to upload new OS for Proteus
Ok I set the Com 4 port `transmit buffer ' to slow as suggested in the post.
No luck still showing OS 2.3. I then set the speed of the com port manually to 2400 baud as an experiment . Still no change.
Should the LCD screen on the Proteus show something when the code is installing. There is just a slowly flashing dot next to letters PC , that shows no sign of change when the comp. is transmitting the OS.
As mentioned before the connection is having no trouble controlling the Proteus from the PC.
Re: Help to upload new OS for Proteus
Ah, there's the problem. Your Proteus needs to be in dL (Download) mode to receive the OS update. (Pages 6 & 9 in the manual)
Try that and see if it works for you!
-Andy.
Re: Help to upload new OS for Proteus
Ah, thanks Andy. I was sure I'd tried DL mode . New OS installed.
Re: Help to upload new OS for Proteus
:oops:
Glad you got it working! :banana:
-Andy.